Case Holders for the IDOD/AUTODOD

Case Holders

Many of the common case holders ordered through us are listed.

If the case holder you are needing is not listed please select the "Other Cartridge" and put in the notes section upon ordering the following:

• Cartridge
• The state the brass is in before turning, New or Fired.
• What Brand/Manufactuer you are using in this case holder.

Wildcat cartridges and other odd ball cartridges will require a custom CNC program to make and will cost $80.00.

All case holders for fired brass will require one piece of fired brass be sent to the following address for proper case holder fitment. Fired brass expands to the inside of your chamber and is now tapered based on your chamber. New brass is made to the manufacturer's standards and will not have the same taper as a fired piece of brass out of your chamber. 

Shipping Address:

FCLASSPRODUCTS

1444 South 8th Street

Phoenix, AZ 85034

• Q: How do I determine proper case holder fitment
• A: The junction where the shoulder and the body of the case meet should be at the opening of the case holder for perfect fitment. There should also be no wobble or wiggle at the front or back end of the case holder, it should be entirely supported by the case holder. If there is wobble then the case will have runout issues and you will not be able to achieve full clean up. 
   
  If the case does not stick out far enough from the case holder the cutters will not cut into the shoulder and potentially cut into your case holder damaging the case holder and your shoulder angle cutters. 
   
  The brass can hang out of the case holder up to a quarter of an inch, if the case hangs out too far, you potentially have the risk of too much projected case run out and may not achieve full cleanup on the case.